Removing The 1U Power Distribution Board - Dell PowerEdge XR8620t Installation And Service Manual

2. Follow the procedure listed in
3. Remove the air shroud.
4. Remove the Riser 1.
Steps
1. Align the slots of the Power distribution board (PDB) with the fix hook on the 2U sled.
2. Using a Phillips 2 screwdriver, tighten the screws to secure the PDB on the 2U sled.
Figure 50. Installing the 2U power distribution board
Next steps
1. Connect the cables connected from cooling fans and system board to the 2U power distribution board (PDB).
2. Install the Riser 1
3. Install the air shroud

Removing the 1U power distribution board

Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
3. Remove the 2u floor from the 1u
4. Disconnect the cables connected from cooling fans and system board to the 1U power distribution board (PDB).
NOTE: Observe the routing of the cable as you remove it from the system.
Steps
1. Using a Phillips 2 screwdriver, remove the screws that secure the PDB to the system.
Before working inside your
Safety instructions.
Before working inside your
node.
system.
system.
Installing and removing system components 79