Adjusting The Steering Head Bearing Play; Greasing The Steering Head Bearing - KTM 250 SX 2018 Owner's Manual

11 SERVICE WORK ON THE CHASSIS
11.12

Adjusting the steering head bearing play

11.13

Greasing the steering head bearing

Main work
–
Move the handlebar to the straight-ahead position. Move the fork legs to and fro in
the direction of travel.
Play should not be detectable on the steering head bearing.
» If there is detectable play:
–
Adjust the steering head bearing play.
–
Move the handlebar to and fro over the entire steering range.
It must be possible to move the handlebar easily over the entire steering range.
H01167-01
There should be no detectable detent positions.
» If detent positions are detected:
–
Adjust the steering head bearing play.
–
Check the steering head bearing and change if necessary.
Finishing work
–
Remove the motorcycle from the lift stand. (
Preparatory work
–
Raise the motorcycle with a lift stand. (
–
Remove the handlebar cushion.
Main work
–
Loosen screws
–
Remove screw
–
Loosen and retighten screw
Guideline
Screw, top steering head
–
Using a plastic hammer, tap lightly on the upper triple clamp to avoid stresses.
–
Tighten screws
K00471-10
Guideline
Screw, top triple clamp
–
Mount and tighten screw
Guideline
Screw, top steering stem
Finishing work
–
Check the play of the steering head bearing. (
–
Remove the motorcycle from the lift stand. (
–
Mount the handlebar cushion.
–
Remove the lower triple clamp.
–
Install the lower triple clamp.
800010-10
1
.
2
.
3
.
1
.
2
.
M8
( p. 45)
( p. 46)
( p. 48)
( p. 48)
p. 42)
p. 42)
M20x1.5 12 Nm (8.9 lbf ft)
M8 17 Nm
(12.5 lbf ft)
20 Nm Loctite
(14.8 lbf ft)
p. 47)
p. 42)
48
® 243™