Table of Contents
Advertisement
14
ELECTRICAL SYSTEM
14.4
Changing the main fuse (All XC models)
Warning
Fire hazard Incorrect fuses overload the electrical system.
–
Only use fuses with the required ampere value.
–
Do not bypass or repair fuses.
Info
The main fuse protects all power consumers of the vehicle. It is located in the starter relay housing under the seat.
–
Connect the battery charger to the battery. Switch on the battery charger.
Battery charger (58429074000)
In addition, this battery charger can be used to test the quiescent current, the start
ability of the battery, and the alternator. With this device, you cannot overcharge
the battery. The charging time may be longer at low temperatures.
–
Switch off the battery charger after charging and disconnect from the battery.
Finishing work
–
Install the battery.
–
Mount the seat. (
Preparatory work
–
Press and hold the kill switch
–
Remove the seat. (
Main work
–
Pull starter relay
F00161-10
–
Take off protection caps
–
Remove faulty main fuse
Info
You can recognize a faulty fuse by a burned-out fuse wire
A spare fuse
–
Install a new main fuse.
Fuse (58011109110) (
–
Check that the electrical equipment is functioning properly.
Tip
Insert a spare fuse so that it is available if needed.
–
Mount the protection caps.
–
Mount the starter relay onto the holder and route the cable.
F00162-10
Finishing work
–
Mount the seat. (
(
p. 81)
p. 53)
while the engine is idling until the engine stops.
p. 52)
1
from the holder.
2
.
3
.
4
is located in the starter relay.
p. 114)
p. 53)
83
A
.
Advertisement
Table of Contents
