Installing The Fork Legs; Removing The Fork Protector - KTM 250 SX 2018 Owner's Manual

11 SERVICE WORK ON THE CHASSIS
11.6

Installing the fork legs

11.7

Removing the fork protector

–
Unscrew screws
–
Unscrew screws
F00011-10
Main work
–
Position the fork legs.
Bleeder screw
Valve
Info
Grooves are milled into the side of the upper end of the fork legs. The sec-
ond milled groove (from the top) must be flush with the top edge of the
upper triple clamp.
H01182-10
The air suspension is located in the left fork leg. The pressure and rebound
damping is located in the right fork leg.
–
Tighten screws
Guideline
Screw, top triple clamp
–
Tighten screws
Guideline
Screw, bottom triple clamp
F00011-11
–
Position the brake caliper. Mount and tighten screws
Guideline
Screw, front brake caliper
–
Position the brake line and clamp. Mount and tighten screws
A00022-11
Finishing work
–
Install the front wheel.
–
Remove screws
–
Remove screws
–
Remove screws
F00024-10
3
. Take out the left fork leg.
4
. Take out the right fork leg.
1
of the right fork leg is positioned to the front.
A
of the left fork leg faces the front.
2
.
3
.
M8
( p. 76)
1
. Remove the clamp.
2
. Take off the left fork protector.
3
. Take off the right fork protector.
M8 17 Nm
(12.5 lbf ft)
M8 12 Nm (8.9 lbf ft)
4 .
25 Nm Loctite
(18.4 lbf ft)
5
.
44
® 243™