Lifting Instructions; Placing; Mains Power Supply - ESAB AristoMig 500 Instruction Manual

GB
5.1

Lifting instructions

Power source
5.2

Placing

Position the welding power source such that its cooling air inlets and outlets are not
obstructed.
5.3

Mains power supply

Recommended fuse sizes and minimum cable areas
AristoMig 500
Mains voltage
Mains cable area, mm
Phase current, I RMS
Fuse
Anti--surge
Type C MCB
NB:
The mains cable areas and fuse sizes as shown above are in accordance with Swedish regulations.
They may not be applicable in other countries: make sure that the cable area and fuse sizes comply
with the relevant national regulations.
ba37d1ea
Trolley and power source
Check that the unit is connected to the correct mains power
supply voltage, and that it is protected by the correct fuse sizes.
A protective earth connection must be made, in accordance
with regulations.
Rating plate with supply connection data
400 V 3µ 50 Hz
400 V
2
4G6
31 A
35 A
40 A
Trolley2 and power source
- - 7 - -