Table of Contents
Advertisement
GB
5.4
Terminating resistor
In order to avoid communication interference, the ends
of the CAN bus must be fitted with terminating
resistors.
One end of the CAN bus is at the control panel, which
has an integral terminating resistor. The other end at
the power source must be fitted with the terminating
resistor, as shown on the right.
6
OPERATION
General safety regulations for the handling of the equipment can be found on
page 3. Read through before you start using the equipment!
6.1
Connections and control devices
1
Connection for cooling water. Not used on
this model.
2
Connection for cooling water. Not used on
this model.
3
Cooling water filler
4
Connection for welding current cable (+)
(MMA welding)
5
Connection for remote control
6
Connection for return cable (--)
7
Main power supply switch, 0 / 1 / START
ba37d1ea
8
White indicating lamp -- Power supply ON
9
Orange indicating lamp -- Overheating
10
Fuse
11
Connection for control cable to the wire
feed unit or for the terminating resistor
12
Connection for welding current to the wire
feed unit
13
Connection for cooling water to the wire
feed unit -- BLUE
14
Connection for cooling water from the wire
feed unit -- RED
- - 8 - -
Advertisement
Table of Contents
