Replacing The Terminal (Optional Step) - ekwb EK-Quantum Vector FE RTX 3090 D-RGB+Backplate User Manual

Gpu water block

Table of Contents

REPLACING THE TERMINAL (Optional Step)

M3 x 12

DIN7991

STEP 3

TERMINAL O-RING

FC TERMINAL

M4 x 24.5 DIN7984 SCREW

STEP 1

- 16 -

STEP 3

After securing the backplate, place the backplate cover on the PCB

and make sure all holes are aligned. Position an M3 X 12 DIN7991

screw in each of the three (3) mounting holes (as shown in the

image) and tighten them evenly with a Allen Key 2mm. Do not use

excessive force!

For this Step, you will need:

Allen Key 2.0 mm

With the EK-Quantum Vector FE RTX 3090 water block, you also

get an additional terminal. Follow these steps to install it.

STEP 1

Unscrew three (3) M4 x 24.5 DIN7984 terminal screws with the

enclosed 2.5mm Allen Key. Remove the stock terminal. Save the

screws and terminal O-Rings for later.

For this Step, you will need:

Allen Key 2.5 mm

M3 x 12 DIN7991 Screw (3 pcs)

Table of Contents

Do you have a question about the EK-Quantum Vector FE RTX 3090 D-RGB+Backplate and is the answer not in the manual?