Summary of Contents for ekwb EK-Quantum Momentum ROG Crosshair VIII Hero
Page 1
EK-Quantum Momentum ROG Crosshair VIII Hero MONOBLOCK USER GUIDE...
Page 2
The following instructions are subject to change without notice. Please visit our web site at www. ekwb.com for updates. Before installation of this product please read important notice, disclosure and warranty conditions printed on the back of the box.
TABLE OF CONTENT PREPARING YOUR MOTHERBOARD REMOVING STOCK COOLER REMOVING OF THE ORIGINAL PLASTIC HOLD-DOWN AND THE FACTORY BACKPLATE APPLYING THERMAL COMPOUND CUTTING THERMAL PADS PLACING THERMAL PADS ON THE MOTHERBOARD PLACING THE BLOCK ON TO MOTHERBOARD ATTACHING BLOCK ON THE MOTHERBOARD CONNECTING THE D-RGB LED STRIP REQUIRED TOOLS SUPPORT AND SERVICE...
PREPARING YOUR MOTHERBOARD REMOVING STOCK COOLER Mosfet screws Remove all encircled screws. There are 4 screws on the back of the motherboard, that need to be removed in order to remove the factory installed MOSFET cooling solution. Additional 4 screws need to be removed to remove I/O cover.
REMOVING OF THE ORIGINAL PLASTIC HOLD-DOWN AND THE FACTORY UNC 6-32 Screws BACKPLATE Using Philips-head screwdriver remove the four UNC 6-32 screws securing the original plastic hold-down clamps around the socket as shown on the sketch. Remove the original backplate and the hold- down clamps.
APPLYING THERMAL COMPOUND Thermal Pad F – 1.0 mm Apply thermal compound on CPU heat spreader (IHS) with enclosed EK-TIM Ectotherm thermal grease. The quantity of about two rice grains is just about right. There is no need to cover the whole IHS. Applying too much thermal grease will have negative impact on the cooling performance! CUTTING THERMAL PADS...
PLACING THE BLOCK ON TO MOTHERBOARD Place the EK-Quantum Momentum ROG Crosshair VIII Hero Monoblock series water block gently to the motherboard or vice versa (as shown on the photo below). Make sure that mounting holes are aligned. ATTACHING BLOCK ON THE MOTHERBOARD M2.5x5 Screws...
STEP 2 For the EK- Quantum Momentum ROG Crosshair VIII Hero Monoblock series water block to operate properly the G1/4 port nearest to the right edge of the water block MUST BE USED AS IMPORTANT: THE INLET PORT. Use this opening as an Inlet Port! EK recommends the use of EK- Fittings.
SUPPORT AND SERVICE For assistance please contact: http://support.ekwb.com/ EKWB d.o.o. Pod lipami 18 1218 Komenda Slovenia - EU SOCIAL MEDIA EKWaterBlocks @EKWaterBlocks ekwaterblocks EKWBofficial ekwaterblocks...
Need help?
Do you have a question about the EK-Quantum Momentum ROG Crosshair VIII Hero and is the answer not in the manual?
Questions and answers