Table of Contents
Advertisement
M2.5 x 7 AX1 SCREWS
BACKPLATE
STEP 2
M3 x 5 SCREW
STEP 3
STEP 2
REMOVING THE STOCK BACKPLATE
Carefully unscrew four (4) preinstalled backplate screws (M2.5 X 7
AX1) and remove the backplate, as shown in the picture. Save the
screws and backplate for later use.
For this Step, you will need:
Phillips Head Screwdriver
STEP 3
REMOVING THE PRE-INSTALLED I/0 BRACKET
Unscrew the three (3) M3X5 screws from the front using Phillips head-
screwdriver and remove the I/O Bracket (as shown in the picture). Save
the screws and I/O Bracket for the later use!
For this Step, you will need:
Phillips Head Screwdriver
- 10 -
Advertisement
Table of Contents
Need help?
Do you have a question about the EK-Quantum Vector FE RTX 3090 D-RGB+Backplate and is the answer not in the manual?