Replacing The Terminal (Optional Step) - ekwb EK-Quantum Vector FE RTX 3080 User Manual

Gpu water block

Table of Contents

REPLACING THE TERMINAL (Optional Step)

TERMINAL O-RING

M4 x 24.5 DIN7984 SCREW

FC TERMINAL

STEP 1

TERMINAL

GASKETS

STEP 2

With the EK-Quantum Vector FE RTX 3080 water block, you also

get an additional terminal. Follow these steps to install it.

STEP 1

Unscrew three (3) M4X24.5 DIN7984 terminal screws with the

enclosed 2.5mm Allen Key. Remove the stock terminal. Save the

screws and terminal O-Rings for later.

For this Step, you will need:

Allen Key 2.5 mm

STEP 2

Before you attach the new terminal, make sure that terminal gaskets

are placed inside holes on the coldplate (as shown in the picture).

For this Step, you will need:

Terminal Gasket (2 pcs)

- 16 -

Table of Contents

Do you have a question about the EK-Quantum Vector FE RTX 3080 and is the answer not in the manual?