Wlan Module - HP ProDesk 600 G5 MT Maintenance And Service Manual

WLAN module

CAUTION: To prevent an unresponsive system, replace the wireless module only with a wireless module
authorized for use in the computer by the governmental agency that regulates wireless devices in your country
or region. If you replace the module and then receive a warning message, remove the module to restore device
functionality, and then contact technical support.
Before removing the WLAN module, follow these steps:
1. Prepare the computer for disassembly (see
2. Remove the access panel (see
3. Remove the front bezel (see
4. Remove the drive cage (see
Remove the WLAN module:
1. Disconnect the WLAN antenna cables (1) from the terminals on the WLAN module.
NOTE:
antenna cable labeled 2/AUX connects to the WLAN module Aux terminal.
2. Remove the Phillips M2.0×3.5 screw (2) that secures the WLAN module to the system board. (The module
tilts up.)
3. Remove the WLAN module (3) by pulling the module away from the slot at an angle.
NOTE:
Reverse this procedure to install the WLAN module.
Access panel on page
Front bezel on page
Drive cage on page
The WLAN antenna cable labeled 1/MAIN connects to the WLAN module Main terminal. The WLAN
WLAN modules are designed with notches to prevent incorrect insertion.
Preparation for disassembly on page
33).
36).
40).
32).
WLAN module 43