Power Supply - HP ProDesk 600 G5 MT Maintenance And Service Manual

Power supply

Follow these steps to remove the power supply:
1. Prepare the computer for disassembly (see
2. Remove the access panel (see
3. Remove the front bezel (see
4. Remove the drive cage (see
Remove the speaker:
1. Position the computer with the rear panel toward you.
2. Disconnect the power supply P1 (1), P2 (2), and P3 (3) cables from the system board.
3. Release the power supply cables from the two cable tie wraps (4).
NOTE:
the power supply spare part kit.
4. Remove the three Torx-15 M3.0×9.0 screws (5) that secure the power supply to the computer chassis.
5. Press down on the power supply release tab (6).
6. Slide the power supply forward, and then lift and remove the power supply (7).
Reverse this procedure to install the power supply.
Access panel on page
Front bezel on page
Drive cage on page
The cable tie wraps will be destroyed in this step. Replacement cable tie wraps are included in
Preparation for disassembly on page
33).
36).
40).
32).
Power supply 47