Steam Anti-Crease - V-ZUG AW V6000 Operating Instructions Manual

11 Trouble-shooting
Display
Hygiene recom-
mendation
Inlet water very
cold:
Heating extended
Too many items:
Heating extended
Large unbalanced
load:
Spin extended
11.2 Other possible problems
Problem
The washing has
not been spun or
has been spun in-
sufficiently.
The appliance vi-
brates heavily
when spinning.
38
Possible cause
▪ No wash cycle has
been carried out at a
temperature of at least
60 °C for a longer
period of time.
▪ Inlet water is very cold.
Heating is extended.
▪ The selected pro-
gramme is intended for
a smaller load. Heating
and possibly rinsing is
extended.
▪ The appliance optimizes
the distribution of the
wash load to com-
pensate an unbalanced
load. The final spin is
extended.
Possible cause
▪ The spin speed is set
too low.
▪ Too unbalanced a load
in the washing drum.
▪ «Steam anti-crease»
was selected and the
appliance was not
standing level.
▪ The transport lock has
not been removed.
▪ The feet of the appli-
ance are not properly
adjusted.
▪ The load could not be
optimally balanced in
the washing drum.
Solution
▸ With one of the next wash cycles
carry out a wash with at least 60° C.
Or:
▸ Run «Appliance hygiene» pro-
gramme without laundry (see page
25).
▸ No action is necessary.
▸ Adjust load to the max. load size
(see page 16).
▸ Wash large and small items together
to avoid large unbalanced loads.
Solution
▸ Increase the spin speed for the next
wash cycle (see page 29).
▸ Wash large and small items to-
gether.
▸ Optimize appliance set-up according
to installation instructions.
▸ Remove transport lock.
▸ Set appliance feet so that the appli-
ance stands level.
▸ Wash large and small items to-
gether.