Table of Contents
Advertisement
Service Manual
Safety Signs
Danger
Warning
Caution
Notice
Alternate
current
Direct current
Grounding
Grounding
Grounding
Close
Open
Power supply
CAT I
CAT II
CAT III
Instruments.uni-trend.com
Indicates a warning of a possible electric shock hazard that could
result in personal injury or death.
Indicates a point requiring caution, which may result in personal
injury or damage to the instrument.
Indicates a potentially hazardous condition that requires following a
procedure or condition that may damage the instrument or other
equipment; if a "Caution" sign is indicated, all conditions must be met
before continuing to operate.
Indicates a potential problem, a procedure, or a condition that needs
to be followed, which may cause the instrument to function
improperly; if the "Caution" mark is marked, all conditions must be
met to ensure that the instrument can function normally.
Instrument AC, please confirm the regional voltage range.
Instrument direct current, please confirm the regional voltage range.
Frame, chassis ground terminal.
Protective earth terminal.
Measure the ground terminal.
The main power is off.
The main power is turned on.
Standby power, when the power switch is turned off, the instrument
is not completely disconnected from the AC power source.
A secondary electrical circuit connected to a wall socket through a
transformer or similar device, such as electronic equipment.
Electronic equipment with protective measures, any high-voltage
and low-voltage circuits, such as copiers inside the office, etc.
CATII: The primary electrical circuit of electrical equipment
connected to the indoor socket through the power cord, such as
mobile tools, home appliances, etc. Household appliances, portable
tools (electric drills, etc.), household sockets, and sockets that are
more than 10 meters away from Category III lines or 20 meters away
from Category IV lines.
Primary circuits of large equipment directly connected to the
distribution panel and circuit connections between the distribution
panel and socket outlets (three-phase distribution circuits including
individual commercial lighting circuits). Equipment with fixed
positions, such as multi-phase motors, and multi-phase gate boxes;
lighting equipment and lines inside large buildings; machine tools and
power distribution panels at industrial sites (workshops), etc.
UTG1000X Series
4 / 20
Advertisement
Table of Contents
