Removing The Rear Panel Assembly - UNI-T UTG1000X Series Service Manual

Service Manual
7、 Remove the keyboard; use a T10 Torque screwdriver to remove the two switch key screws, and then
remove the 8 fixing screws of the keyboard to remove the keyboard and the screen.
Note: Before removing the keyboard, the knob on the front panel needs to be removed.
8、

Removing the rear panel assembly

The following procedure describes the removal and replacement of the rear panel assembly.
Prerequisites:
To prevent electrostatic damage to components, wear a properly grounded antistatic wrist and foot

strap during installation, and use an antistatic mat in a tested antistatic environment.
Remove the rear cover.

Steps:
1. After step 3 of removing the front panel, gently pull the rear cover to remove it, as shown in the figure
below:
2. Remove the power module; use a T10 Torque screwdriver to remove the 6 screws and the wiring harness,
as shown in the figure below:
Instruments.uni-trend.com
To reinstall, reverse the above steps.
UTG1000X Series
16 / 20