Table of Contents
Advertisement
Service Manual
5.Disassemble
Removal tool
Use the following tools to remove or replace modules in the function/arbitrary waveform generator.
Item
1
2
3
Remove the handle
The following procedure describes the removal and replacement of the handle.
Steps:
1: After turning to the picture below, pull the handles on both sides outward to remove the handles:
Remove the screws on the left and right sides of the middle
frame
The following procedure describes the removal and replacement of the front and rear covers.
Prerequisites:
To prevent electrostatic damage to components, wear a properly grounded antistatic wrist and foot
strap during installation, and use an antistatic mat in a tested antistatic environment.
Steps:
1: Use a T10 Torque screwdriver to remove the screws on the left and right panels of the instrument, a total
of 9 screws, as shown in the figure below:
Instruments.uni-trend.com
Tools
Torque screwdriver
Upholstered
Anti-static
environments
Description
Model see disassembly steps
Prevents damage to the screen and knobs when removing the
front panel
To prevent damage to devices caused by static electricity, wear
properly grounded anti-static clothing, wrist straps, and foot
straps; effective anti-static mats
UTG1000X Series
13 / 20
Advertisement
Table of Contents
