13
SERVICE WORK ON THE CHASSIS
A
0 0 A
B
0 0 0 B
1 2 3
–
Pull the lower chain section with specified weight
Guideline
Weight, chain wear measurement
–
Measure distance
Maximum distance
chain section
»
If distance
–
18 19 20
401288-10
–
Push the chain up in the area behind the chain guide.
–
Check the chain sliding guard for wear.
»
If the chain sliding guard has lost material due to wear to the extent that, in
area
–
–
Check that the chain sliding guard is firmly seated.
»
If the chain sliding guard is loose:
–
V00602-10
B
of 20 chain rollers in the lower chain section.
Info
Chain wear is not always even, so you should repeat this measurement at differ-
ent chain positions.
B
at the longest
B
is greater than the specified measurement:
Change the drivetrain kit.
Info
When a new chain is mounted, the rear sprocket and engine sprocket
should also be changed.
New chains wear out faster on old, worn sprockets.
C
, the drilled hole of screw
Change the chain sliding guard.
Tighten the screws on the chain sliding guard.
A
.
15 kg (33 lb.)
301.6 mm (11.874 in)
1
is visible from above:
93