Table of Contents
Advertisement
15
WHEELS, TIRES
–
Clean the thread of the wheel spindle and nut
–
Clean and grease wheel spindle.
Long-life grease (
–
Clean the mating surfaces of the brake caliper support and swingarm.
–
Position the rear wheel.
The brake linings are correctly positioned.
–
Push the rear wheel forward as far as possible and lay the chain on the rear sprocket.
–
Pull the rear wheel back and mount wheel spindle
5
adjusters
Info
Mount left and right chain adjusters
–
Mount nut
–
Ensure that the chain adjusters lie flat on the screws and tighten the nut
Guideline
In order for the rear wheel to be correctly aligned, the markings on the left and right
chain adjusters must be in the same position relative to reference markings
V00162-12
Nut, rear wheel spindle
–
Position wheel speed sensor
Guideline
Screw, wheel speed sensor holder
Finishing work
–
Check the chain tension. (
–
Remove the rear of the motorcycle from the lifting gear. (
p. 189)
.
3
, but do not tighten it yet.
6
in the drill hole. Mount and tighten screw
p. 88)
3
.
4
with the washers and chain
5
in the same position.
M14x1.5
90 Nm
(66.4 lbf ft)
M6
8 Nm (5.9 lbf ft)
p. 80)
123
3
.
B
.
7
.
Advertisement
Table of Contents
