Assembly; Remove The Pressure Washer From The Shipping Carton; Assemble The Frame - Champion Power Equipment C24065 Owner's Manual

Assembly

Assembly
Your pressure washer requires some
assembly. This unit ships from our factory
without oil. It must be properly serviced
with fuel and oil before operation.
If you have any questions regarding the
assembly of your pressure washer, call our
help line at 1-877-338-0999. Please have
your serial number and model number
available.
Remove the Pressure Washer
from the Shipping Carton
1. Set the shipping carton on a solid, flat
surface.
2. Remove everything from the carton
except the pressure washer.
3. Carefully cut each corner of the box
from top to bottom. Fold each side flat
on the ground to provide a surface area
to install the wheel kit and support legs.
Install the Wheel Kit
CAUTION
The wheel kit is not intended for over-the-road
use.
You will need the following tools to install
the wheels:
10, 12 mm wrench
Socket wrench with a 8, 10,12 mm
sockets
Pliers
1. Before adding oil to the engine, tip the
pressure washer slowly so that the pump
side is up.
2. Each wheel needs: 1 bolt, 1 nut, 2
washers, 1 axle sleeve.
3. Place axle sleeve inside of wheel. Place 1
washer on the bolt, and send it through
wheel. Place other washer on, then send
bolt through mounting bracket. Secure
and tighten with lock nut.
4. Repeat step 3 to attach the second
wheel.
8
Install Support Legs
1. Attach each rubber vibration mount to
each support leg with a cap screw
(M8x10).
2. Attach each support leg to mounting
brackets using cap screws and lock nuts
provided.
3. Tip the pressure washer slowly so that it
rests on the wheels and support leg.

Assemble the Frame

1. Locate the frame handle.
2. Insert frame handle into base frame and
secure with hitch pins.
3. Locate the hose and gun holster.
4. Place onto frame handle and align with
pre-drilled holes.
5. Secure with provided cap screws and
lock nuts. Tighten with 10mm wrench
Rev C24065-20080409