Function Of The Displays - Fujitsu SE500 Basic Operating Manual

Control panel (on the SE700 and SE500)

5.3.1 Function of the displays

POWER ON
Lights up green after the system power controller has completed the power-up
sequence without error. In the standby status the indicator flashes.
SYSTEM
Lights up green when the CPU(s) is/are in operation.
CHECK
Lights up red when the SVP has detected a hardware malfunction or a fault in the power
supply of the SU /390. In the event of a fault a buzzer sounds at the same time.
STATUS indicator
Depending on the POWER ON indicator, this indicator is switched on and displays details
of the hardware status with a three-character alphanumeric display.
The display changes as sequences are executed. If the display finally stops at a particular value not
equal to "000", this must be interpreted as the error code for a problem. In this case Customer Support
should be contacted.
POWER ON
Does not light
up
Does not light
up
Flashing
Lights up
Lights up
Lights up
Lights up
Lights up
Lights up or
does not light
up (depending
on the
STATUS)
Lights up
Table 1: STATUS indicator
46
STATUS indicator
Does not light up
b00 through bFF
Does not light up (in maintenance mode
CE0)
001 through 010
100 through 399
000
500 through 599
010 through 001
Begins with A
EEE
Hardware status
Power failure
Power supply units are being initialized.
Standby mode
Power-on sequence is active.
System is being initialized.
System initialization completed.
System stop initiated.
Power-off sequence is active.
The entire /390 system (CPU box,
AROMA, CHE boxes) or parts of it have
been switched off because of a fault
(power supply or operating temperature).
Or an important function of the SVP has
been stopped and a detailed error code
cannot be displayed on the SVP console.
Another error has occurred. A detailed
error code is displayed on the SVP
console.
Controls
U41858-J-Z126-2-76