Stand-By Key - Fujitsu SE500 Basic Operating Manual

Control panel (on the SE700 and SE500)
2. The status indicator displays no error code. If an error code is displayed, notify
Customer Service of this error code.
Press the POWER ON key to begin powering up the system. The power-up sequence
begins. POWER ON lights up and the status indicator displays a sequence from 001
through 399 while powering up.
The system is ready when POWER ON lights up and the status indicator displays 000. If
the status indicator displays an error code, an error occurred while powering up. In this case
notify Customer Service of this error code.
5.3.2.3

STAND-BY key

This key is used to switch off the power supply of the entire /390 system. It is switched off
independently of an automatic power-on/off function.
v
w
Press the STAND-BY key to initiate system power-off. The power-off sequence begins.
While the system is powering off, the status indicator displays a sequence from 501 through
599. When the Server Unit is switched off, POWER ON flashes and the status indicator
display is empty.
Instead of using the key, the system can also be switched to standby using the SVP frame
(AU4) POWER STAND-BY/IMPL. See the "Server Unit /390" Operating Manual [2].
48
CAUTION!
There is a risk of data loss. When standby mode is switched to (using the key or the
SVP frame), it is not guaranteed that system data can be written back. Terminate
applications which are running beforehand and shut down the operating system.
IMPORTANT!
In standby mode some of the circuits remain live!
Controls
U41858-J-Z126-2-76