TOHATSU MFS 4C Owner's Manual page 63

MFS4-5-6C_EUR_EN_141119N.book 63 ページ ２０１４年１２月６日 土曜日 午後７時４２分
9. Stand the outboard motor up vertically
in a dry place.
ENOW00066-0
CAUTION
Do not carry or store outboard motor in
any of positions described below.
Otherwise, engine damage or property
damage could result from leaking oil.
ENON00021-A
Note
 If the outboard motor must be laid down
be sure drain the fuel and engine oil,
then the outboard motor on a cushion
as shown in the drawing below (See
page 79 and 68).
 Elevate power unit 2 inches to 4 inches if
traveling to avoid oil spillage.
INSPECTION AND MAINTENANCE
ENOM00950-0
Adding a fuel stabilizer
When adding a fuel stabilizer additive
(commercially available), first fill the fuel
tank with fresh fuel. If the fuel tank is only
partially filled, air in the tank can cause the
fuel to deteriorate during storage.
1. Before adding fuel stabilizer additive,
ENOF01511-0
drain the carburetor (See page 64).
2. Follow the instructions on the label
when adding the fuel stabilizer additive.
3. After adding the additive, let the out-
board motor run in the water for 10
minutes to make sure any old fuel in
the fuel system has been completely
replaced by the fuel with additive.
4. Turn the engine OFF
ENON00891-0
Note
If your motor is used occasionally, it is rec-
ommended to use a good fuel stabilizer in
every tank of fuel and keep the container full
to reduce condensation and evaporation.
ENOF01510-0
63
ENOF01512-0
10