TOHATSU MFS 4C Owner's Manual page 50

MFS4-5-6C_EUR_EN_141119N.book 50 ページ ２０１４年１２月６日 土曜日 午後７時４２分
50
INSPECTION AND MAINTENANCE
.
1
1. Flushing attachment (option)
2. Gardenhose (commercial available)
ENOM00085-A
Flushing by test tank
ENOW00081-0
WARNING
Do not start engine without removing pro-
peller, or accidentally turning propeller
could cause personal injury.
ENOW00082-0
WARNING
Never start or operate the engine indoors
or in any space which is not well ventilated.
10
Exhaust gas contains carbon monoxide, a
colorless and odorless gas which can be
fatal if inhaled for any length of time.
ENOW00036-A
CAUTION
When the engine is started in the test tank,
to avoid over heating and water pump
damage, be sure the water level is at least
10 cm (4 in.) above the anti ventilation
plate.
And be sure to remove the propeller, when
starting the engine in the test tank. (See
page 57)
Run the engine only at idling.
2
ENOF00449-0
1
1. Over 10 cm (4 in.)
ENOM00950-0
Fuse replacement (for SP type)
ENOW00923-0
CAUTION
Before replacing a fuse, disconnect the
battery cable from the battery negative (-)
terminal. Failure to do so may cause a
short-circuit.
ENOW00924-0
CAUTION
Never use a fuse with a rating that exceeds
the specified rating as this could cause
serious damage to the electrical system.
If a blown fuse is detected, try to deter-
mine the cause for this and correct it. If the
cause for the problem is not corrected, the
fuse will likely blow again.
If the fuse continues to blow, request an
authorized Tohatsu dealer to inspect the
outboard motor.
1. Stop the engine and disconnect the
battery cable from the battery negative
(-) terminal.
2. Remove the engine cover.
ENOF00863-0