TOHATSU MFS 4C Owner's Manual page 57

MFS4-5-6C_EUR_EN_141119N.book 57 ページ ２０１４年１２月６日 土曜日 午後７時４２分
ENOW00928-0
CAUTION
Wipe off gear oil well immediately if spilled
and dispose of it in accordance with local
fire prevention and environment protection
regulations.
ENON00032-0
Note
If water in the oil, giving it a milky colored
appearance. Contact your dealer.
ENON00033-0
Note
Use genuine gear oil or the recommended
one (API GL-5: SAE #80 to #90).
Required volume: approx. 320 mL (10.8
fl.Oz).
ENOM00086-A
Propeller replacement
ENOW00084-0
WARNING
 Do not begin propeller removal and
installation procedure with spark plug
c a p s a t t a c h e d , s h i f t i n f o r w a rd o r
reverse, main switch at other than
"OFF", engine stop switch lock attached
to the switch, and starter key attached,
or engine could accidentally start lead-
ing to serious personal injury. Discon-
nect battery cable if possible.
 The propeller edge is thin and sharp.
Wear the groves during replacement to
protect your hands.
ENOW00086-0
CAUTION
 Do not install propeller without thrust
holder, or propeller boss could be dam-
aged.
 Do not reuse split pin.
INSPECTION AND MAINTENANCE
 After installing split pin, spread the pin
apart to prevent it from falling out which
could lead to the propeller coming off
during operation.
A worn-out or bent propeller will lower the
motor's performance, and cause engine
trouble.
1. Put a piece of wood block between
propeller blade and anti-ventilation
plate to hold propeller.
2. Remove the split pin, propeller nut and
washer.
3. Remove the propeller and thrust
holder.
4. Apply water proof grease to the pro-
peller shaft before installing a new pro-
peller.
5. Install the thrust holder, propeller,
stopper, washer and propeller nut onto
the shaft.
57
ENOF00084-B
10