ZyXEL Communications NR Series User Manual page 312

The following table describes the labels in this screen.
Table 134 Maintenance > Firmware Upgrade
LABEL DESCRIPTION
Upgrade Firmware
Reset All Select this to reset all your configurations, including Mesh WiFi settings, to the factory defaults
Settings After
after firmware upgrade. Otherwise, make sure this is cleared if you do not want the Zyxel
Firmware
Device to lose all its current configurations and return to the factory defaults.
Upgrade
Note: Make sure to back up the Zyxel Device's configuration settings first in case the
Current This is the current firmware version.
Firmware
Version
File Path Enter the location of the file you want to upload in this field or click Choose File/Browse to find
it.
Choose File/ Click this to find the .bin file you want to upload. Remember that you must decompress
Browse
compressed (.zip) files before you can upload them.
Upload Click this to begin the upload process. This process may take up to 3 minutes.
Do Online Firmware Upgrade
Check for With the Zyxel Device connected to the Internet, click this to check for new firmware online
Latest
from the Zyxel server. If a newer firmware is available, follow the online prompt to upload the
Firmware
new firmware to your Zyxel Device.
Now
After you see the firmware updating screen, wait a few minutes before logging into the Zyxel Device
again.
Figure 191 Firmware Uploading
The Zyxel Device automatically restarts in this time causing a temporary network disconnect. In some
operating systems, you may see the following icon on your desktop.
Figure 192 Network Temporarily Disconnected
After 2 minutes, log in again and check your new firmware version in the Connection Status screen.
If the upload was not successful, an error screen will appear. Click OK to go back to the Firmware
Upgrade screen.
Chapter 34 Firmware Upgrade
reset all settings process is not successful. Refer to
NR/FWA Indoor Series User's Guide
312
Section 35.2 on page 314.