ZyXEL Communications NR Series User Manual page 182

Figure 111 Network Setting > QoS > General
The following table describes the labels in this screen.
Table 60 Network Setting > QoS > General
LABEL DESCRIPTION
QoS Click this switch to enable QoS to improve your network performance.
WAN Managed Enter the amount of upstream bandwidth for the WAN interfaces that you want to allocate using
Upstream QoS.
Bandwidth
The recommendation is to set this speed to match the interfaces' actual transmission speed. For
example, set the WAN interfaces' speed to 100000 kbps if your Internet connection has an
upstream transmission speed of 100 Mbps.
You can also set this number lower than the interfaces' actual transmission speed. This will cause
the Zyxel Device to not use some of the interfaces' available bandwidth.
If you leave this field blank, the Zyxel Device automatically sets this number to be 95% of the
WAN interfaces' actual upstream transmission speed.
LAN Managed Enter the amount of downstream bandwidth for the LAN interfaces (including WLAN) that you
Downstream want to allocate using QoS.
Bandwidth
The recommendation is to set this speed to match the WAN interfaces' actual transmission
speed. For example, set the LAN managed downstream bandwidth to 100000 kbps if you use a
100 Mbps wired Ethernet WAN connection.
You can also set this number lower than the WAN interfaces' actual transmission speed. This will
cause the Zyxel Device to not use some of the interfaces' available bandwidth.
If you leave this field blank, the Zyxel Device automatically sets this to the LAN interfaces'
maximum supported connection speed.
Cancel Click Cancel to restore your previously saved settings.
Apply Click Apply to save your changes.
Chapter 11 Quality of Service (QoS)
NR/FWA Indoor Series User's Guide
182