E-Mail Notification Edit - ZyXEL Communications NR Series User Manual

The following table describes the labels in this screen.
Table 131 Maintenance > E-mail Notification
LABEL
Add New e-mail
Mail Server
Address
Username
Port
Security
E-mail Address
Modify
Remove

32.2.1 E-mail Notification Edit

Click the Add button in the E-mail Notification screen. Use this screen to configure the required
information for sending email through a mail server.
Figure 187 Maintenance > E-mail Notification > Add
The following table describes the labels in this screen.
Table 132 Maintenance > E-mail Notification > Add
LABEL
Mail Server
Address
Port
Authentication
Username
Chapter 32 Email Notification
DESCRIPTION
Click this button to create a new entry (up to 32 can be created).
This displays the server name or the IP address of the mail server.
This displays the user name of the sender's mail account.
This field displays the port number of the mail server.
This field displays the protocol used for encryption.
This field displays the email address that you want to be in the from or sender line of the email
that the Zyxel Device sends.
Click the Edit icon to configure the entry.
Click the Delete icon to remove the entry.
Click this button to delete the selected entries.
DESCRIPTION
Enter the server name or the IP address of the mail server for the email address specified in the
Account e-mail Address field.
If this field is left blank, reports, logs or notifications will not be sent through email.
Enter the same port number here as is on the mail server for mail traffic.
Enter the user name. Up to 32 printable ASCII characters are allowed except [ " ], [ ` ], [ ' ], [ < ], [
> ], [ ^ ], [ $ ], [ | ], [ & ], or [ ; ]. This is usually the user name of a mail account you specified in the
Account email Address field.
NR/FWA Indoor Series User's Guide
305