Device Access Problems - ZyXEL Communications NR Series User Manual

Inspect your cables for damage. Contact the vendor to replace any damaged cables.
3
Turn the Zyxel Device off and on.
4
If the problem continues, contact the vendor.
5

37.3 Device Access Problems

I do not know the IP address of the Zyxel Device.
The default IP address is 192.168.1.1
1
If you changed the IP address, you might be able to find the IP address of the Zyxel Device by looking
2
up the IP address of your computer's default gateway. To do this in Microsoft Windows, click Start > Run,
enter cmd, and then enter ipconfig. The IP address of the Default Gateway might be the IP address of
the Zyxel Device, depending on your network environment.
If this does not work, reset the Zyxel Device to its factory defaults. Refer to
3
I forgot the admin password.
See the Zyxel Device label or this document's cover page for the default admin password.
1
If you changed the password from default and cannot remember the new one, you have to reset the
2
Zyxel Device to its factory default settings. Refer to
I cannot access the Web Configurator login screen.
Make sure you are using the correct IP address.
1
• The default IP address is 192.168.1.1.
• If you changed the IP address
• If you changed the IP address and have forgotten the new address, see the troubleshooting
suggestions for
Check the hardware connections, and make sure the LEDs are behaving as expected.
2
Make sure your Internet browser does not block pop-up windows and has JavaScript and Java
3
enabled.
Reset the Zyxel Device to its factory default, and try to access the Zyxel Device with the default IP
4
address.
Chapter 37 Troubleshooting
(Section 9.2 on page
I do not know the IP address of the Zyxel Device.
NR/FWA Indoor Series User's Guide
322
Section 35.2 on page
Section 35.2 on page 314.
151), use the new IP address.
314.