Add Or Edit Dns Route; Policy Route - ZyXEL Communications NR Series User Manual

Table 55 Network Setting > Routing > DNS Route (continued)
LABEL
WAN Interface
Subnet Mask
Modify

10.3.1 Add or Edit DNS Route

You can manually add the Zyxel Device's DNS route entry. Click Add New DNS Route in the DNS Route
screen, use this screen to configure the required information for a DNS route.
Figure 107 Network Setting > Routing > DNS Route > Add New DNS Route
The following table describes the labels in this screen.
Table 56 Network Setting > Routing > DNS Route > Add New DNS Route
LABEL
Active
Domain Name
Subnet Mask
WAN Interface
OK
Cancel

10.4 Policy Route

By default, the Zyxel Device routes packets based on the shortest path to the destination address. Policy
routes allow you to override the default behavior and route packets based on other criteria, such as the
Chapter 10 Routing
DESCRIPTION
This is the WAN interface through which the matched DNS request is routed.
This parameter specifies the IP network subnet mask.
Click the Edit icon to configure a DNS route on the Zyxel Device.
Click the Delete icon to remove a DNS route from the Zyxel Device.
DESCRIPTION
Enable DNS route in your Zyxel Device
Enter the domain name you want to resolve. Up to 64 printable ASCII characters are allowed
except [ " ], [ ` ], [ ' ], [ < ], [ > ], [ ^ ], [ $ ], [ | ], [ & ], or [ ; ].
You can use the wildcard character, an "*" (asterisk) as the left most part of a domain name,
such as *.example.com. The Zyxel Device forwards DNS queries for any domain name ending in
example.com to the WAN interface specified in this route.
Enter the subnet mask of the network for which to use the DNS route in dotted decimal
notation, for example 255.255.255.255.
Select a WAN interface through which the matched DNS query is sent. You must have the WAN
interfaces already configured in the Broadband screen.
Click this to save your changes.
Click this to exit this screen without saving.
NR/FWA Indoor Series User's Guide
.
175