User Account Add Or Edit - ZyXEL Communications NR Series User Manual

Table 121 Maintenance > User Account (continued)
LABEL
Modify
Cancel
Apply

28.2.1 User Account Add or Edit

Add or change the name of the user account, set the security password and the retry times, and
whether this user will have Administrator or User privileges. Click Add New Account or the Edit icon of an
existing account in the Maintenance > User Account to open the following screen.
Figure 177 Maintenance > User Account > Add
The following table describes the labels in this screen.
Table 122 Maintenance > User Account > User Account Add/Edit
LABEL
Active
User Name
Password
Verify Password
Retry Times
Chapter 28 User Account
DESCRIPTION
Click the Edit icon to configure the entry.
Click the Delete icon to remove the entry.
Click Cancel to restore your previously saved settings.
Click Apply to save your changes.
DESCRIPTION
Click to enable (switch turns blue) or disable (switch turns gray) to activate or deactivate the
user account.
Enter a name for this account. Up to 31 printable ASCII characters are allowed except [ " ], [ ` ], [
' ], [ < ], [ > ], [ ^ ], [ $ ], [ | ], [ & ], or [ ; ].
Enter your new system password. Enter 6 – 64 printable ASCII characters and must contain at
least one numeric and one alphabetic character.
Note that as you type a password, the screen displays a (*) for each character you type. After
you change the password, use the new password to access the Zyxel Device.
If you are changing your existing password, you have to first enter your Old Password then enter
your New Password.
Enter the new password again for confirmation.
Enter the number of times consecutive wrong passwords can be entered for this account. 0
means there is no limit.
NR/FWA Indoor Series User's Guide
290