Table Of Contents Introduction Controls and Indicators Installation Operation Obtaining Service Troubleshooting Replacing the Battery Specifications Limited Product Warranty A1. Declaration of Conformity...
Please read ATTENTION! Cette série d'onduleurs est uniquement destinée à être installée this manual before installing your Enspire Series UPS, models EN750LCD, dans un environnement intérieur à température contrôlée, exempt de contaminants EN900LCD as it provides important information that should be followed during conducteurs.
Page 4
WARNING: Qualified Service Personnel ONLY must perform the Installa- self-test the UPS will be ready for normal operation. To turn tion and Servicing of these UPS systems. MINUTEMAN accepts no liabilities the UPS off: press and hold the On/Off button until the alarm and is not limited to: injury to the Service Personnel, or damages to;...
Model # Input Power Cord Output Power Receptacles ranty, guarantee, or undertaking, either expressly or implicitly, including but EN750LCD 5 - NEMA 5-15R Battery Backup & Surge not limited to the completeness, faultlessness, accuracy, non-infringement, NEMA 5-15P W/6 ft cord...
The AC normal icon will be on when the UPS is operating in the Chapter 3: Installation normal AC mode and will turn off when the UPS is operating in the Battery mode. INSTALLATION PLACEMENT The On-Battery icon will turn on when the UPS is operating in the Battery mode and will turn off when the UPS is operating in the AC normal mode.
Page 7
Please go to our web site at www.minutemanups.com/support, then printer, copier, vacuum cleaner or any other large electrical device into the output of look under Downloads, and then Software Download Center. Please download the UPS. (Free of Charge) the latest version of the Minuteman SentryHD software.
USB COMMUNICATIONS PORT CONNECTION (OPTIONAL) TURNING THE UPS ON / OFF The EN750LCD and EN900LCD support USB communications. The power moni- To turn the UPS on: press and hold the On/Off button until the alarm sounds one beep and then release. Then in aproximately twenty seconds the UPS will perform a five toring software and interface cable can be used with the UPS.
RMA # marked on the outside of the package. Beeping 6. Return the unit by insured, prepaid carrier to: The unit is off, plugged into Para Systems Inc. MINUTEMAN UPS the wall outlet 1809 W. Frankford Road, Suite 150 and charging Carrollton, TX 75007 the battery...
Chapter 6: Troubleshooting Chapter 7: Replacing the Battery REPLACING THE BATTERY Symptom / Error Code Cause / What To Do (QUALIFIED SERVICE PERSONNEL ONLY) Press the On/Off button and release after one beep. UPS will not turn on. Please read all of the WARNINGS and CAUTIONS before attempting to ser- Reset the input circuit breaker by pressing the UPS operates in battery vice the batteries.
Page 11
9. Disconnect the battery positive (Red) wire and set the old battery module ne requièrent aucun entretien. aside. (FIG. 2) Do not short the battery positive wire to the battery negative wire. EN750LCD EN900LCD Model # Verify proper polarity. Connect the battery positive (Red) wire to the battery po-...
FIG. 2 Chapter 8: Specifications SYSTEM SPECIFICATIONS Model Number EN900LCD EN750LCD Topology Standby, Simulated Sine Wave 900VA 750VA Maximum Power Capacity 450W 500W INPUT Number of Phase Single (1∅ 2W +G) Nominal Voltage 120VAC Acceptable Input voltage 0 - 150VAC...
Chapter 9: Limited Product Warranty BATTERY SYSTEM Battery Type Sealed, Non-Spillable, Maintenance Free, Value Regulated Lead Acid Para Systems, Inc. (Para Systems) warrants this equipment, when properly applied and Typical Recharge Time 8-hours to 90% capacity from a full load discharge operated within specified conditions, against faulty materials (excluding the batteries) or Typical Battery Life 3 to 5 years.
Need help?
Do you have a question about the EN750LCD and is the answer not in the manual?
Questions and answers