Table of Contents
Advertisement
4.
Remove the drive backplane
5.
Remove the cooling fan cage
Steps
1. Disconnect the right control panel cable and the VGA cable from the connectors on the system board.
NOTE:
Observe the routing of the cable as you remove it from the system.
2. Remove the cable from cable clip.
3. Using the Phillips #1 screwdriver, remove the screws that secures the right control panel and cable cover to the system.
4. Holding the right control panel assembly, remove the control panel along with the cable from the system.
NOTE:
The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Figure 111. Removing the right control panel
Next steps
Replace the right control
Installing the right control panel
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the air
shroud.
4.
Remove the drive backplane
5.
Remove the cooling fan cage
cover.
assembly.
panel.
Safety
Before working inside your
cover.
assembly.
instructions.
system.
Installing and removing system components
113
Advertisement
Table of Contents
