Rear View Of The System - Dell EMC PowerEdge R550 6PX6M Installation And Service Manual

NOTE: For more information, see the Dell EMC PowerEdge R550 Technical Specifications on the product documentation
page.

Rear view of the system

Figure 7. Rear view of the system
Table 7. Rear view of the system
Item Ports, panels, or slots
1 PCIe expansion card slot 1 N/A
2 PCIe expansion card slot
2
3 PCIe expansion card slot
5
4 System identification
button
5 PCIe expansion card slot
6
6
BOSS S2 module
7
Power supply unit (PSU
2)
8
Power supply unit (PSU 1)
9
VGA port
10 OCP NIC port (optional)
11 USB 3.0 port
12 USB 2.0 port
Icon Description
Enables you to connect PCI Express expansion cards.
N/A Enables you to connect PCI Express expansion cards.
N/A Enables you to connect PCI Express expansion cards.
Press the system ID button:
● To locate a particular system within a rack.
● To turn the system ID on or off.
To reset iDRAC, press and hold the button for more than 16
seconds.
NOTE:
● To reset iDRAC using system ID, ensure that the system ID
● If the system stops responding during POST, press and hold
N/A Enables you to connect PCI Express expansion cards.
N/A Enables you to connect BOSS S2 module.
Indicates the PSU 2.
Indicates the PSU 1.
Enables you to connect a display device to the system.
N/A This port supports OCP 3.0. The NIC ports are integrated on the
OCP card which is connected to the system board.
This port is USB 3.0-compliant.
This port is USB 2.0-compliant.
button is enabled in the iDRAC setup.
the system ID button (for more than 5 seconds) to enter
the BIOS progress mode.
System overview 13