Figure 90. Removing the OCP card
4. If the OCP card is not going to be replaced, install a filler bracket.
Next steps
Replace the OCP
card.
Installing the OCP card
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the OCP
shroud.
Steps
1. If installed, remove the filler bracket.
2. Open the blue latch on the system board.
3. Slide the OCP card into the slot in the system.
4. Push until the OCP card is connected to the connector on the system board.
5. Close the blue latch to lock the OCP card to the system.
Figure 91. Installing the OCP card
Safety
instructions.
Before working inside your
system.
Installing and removing system components
93