Table of Contents
Advertisement
Figure 59. Removing the retaining clip
Next steps
Replace the processor into a processor and heat sink module
Installing the processor into a processor and heat sink module
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the air
shroud.
4.
Remove the processor heat sink
Steps
1. Place the processor in the processor tray with the connector side facing down.
NOTE:
Ensure that the pin 1 indicator on the processor tray is aligned with the pin 1 indicator on the processor.
2. Place the retaining clip on top of the processor in the processor tray aligning pin 1 indicator on the processor.
NOTE:
Ensure the pin 1 indicator on the retaining clip is aligned with the pin 1 indicator on the processor before placing
the retaining clip on the processor
NOTE:
Before you install the heat sink, ensure to place the processor and retaining clip in the tray
68
Installing and removing system components
Safety
instructions.
Before working inside your
module.
(PHM).
system.
Advertisement
Table of Contents
