Lan Properties - Polycom QSX Administrator's Manual

LAN Properties

To configure LAN properties:
1. Log on to the QSX Admin Web as described on
2. Go to Admin Settings > LAN Properties.
3. Configure these settings:
Setting
Host Name
(default: serial number)
IP Address
(default: Obtain IP address automatically)
Your IP Address is
or
Use the Following IP Address
DNS Servers
Default Gateway
Subnet Mask
WINS Server
WINS Resolution
(default: disabled)
LAN Speed
(default: Auto)
Duplex Mode
(default: Auto)
Page 23.
Description
Indicates the system's DNS name. If you change the
Host Name, the system restarts.
Specifies how the system obtains an IP address.
• Obtain IP address automatically — Select if the
system gets an IP address from the DHCP server on
the LAN.
• Enter IP address manually — Select if the IP
address will not be assigned automatically.
Displays the IP address currently assigned to the
system if the system obtains its IP address
automatically.
Allows you to enter the IP address for the system if
Enter IP address manually is selected.
Displays the DNS servers currently assigned to the
system. If the system does not automatically obtain
a DNS server address, enter up to four DNS servers
here.
Displays the gateway currently assigned to the
system. If the system does not automatically obtain
a gateway IP address, enter one here.
Displays the subnet mask currently assigned to the
system. If the system does not automatically obtain
a subnet mask, enter one here.
Displays the WINS server currently assigned to the
system. If the system does not automatically obtain
a WINS server IP address, enter one here.
Sends a request to the WINS server for WINS name
resolution.
Specifies the LAN speed to use. Note that the speed
you choose must be supported by the switch.
Choose Auto to have the network switch negotiate
the speed automatically. If you choose 10 Mbps or
100 Mbps, you must also select a duplex mode.
Choose Auto to have the network switch negotiate
the Duplex mode automatically, or specify the
Duplex mode to use. Note that the Duplex mode you
choose must be supported by the switch.
38