Enabling The Vsx 8000 To Work With A Vortex Device - Polycom Vortex EF2241 Application Note

You may use either the left or right channels for sending and receiving monaural audio to
the VSX 8000. For stereo operation, both the left and right channels must be used.
Please follow our instructions for wiring the Vortex device to the codec (See the section
W VSX 8000
IRING FROM
noise into the signals sent and received from the codec.
E
NABLING THE
1. Connect a video monitor to Video Output 1 of the codec.
2. On the VSX 8000 User Interface, go to S
Page 2. Select the L
3. (Optional) Enable the VSX 8000 to control the Vortex Device by setting Serial Port 1 or Serial Port 2
to Vortex Mixer. In the VSX 8000 User Interface, go to S
S P . For the appropriate port, select V
ERIAL ORTS
rate of the VSX 8000 matches the baud rate of the Vortex Device. See the page C
V D
ORTEX EVICE VIA THE
4. Once that is completed, make sure that the Codec Input to the Vortex Device is assigned to the
appropriate AEC Reference signal if the VSX 8000 will be used in Mono mode (Standard AEC
Operation). If using InstantDesigner to create the configuration settings for the Vortex, the
reference will be set automatically. For Stereo Mode, please refer to the S
section of the Vortex/VSX 8000 Integration Application Note.
V D
TO ORTEX EVICE
VSX 8000
TO WORK WITH A
YSTEM
I option for the Input Type. Set the Level setting to 5.
INE NPUT
VSX8000 for more information.
). Failure to do so may induce him and ground
, A S , A
DMIN ETTINGS UDIO
, A
YSTEM DMIN
M for RS-232 Mode. Verify that the baud
ORTEX IXER
V D
ORTEX EVICE
S , and select N
ETTINGS EXT
S , G S
ETTINGS ENERAL ETTINGS
ONTROLLING A
AEC O
TEREO PERATION
for
,
54