Gree SAP24HP230V1A Service Manual page 69

3.9 E-heater Setting
E-heater (auxiliary electric heating function): In the Heating mode, E-heater is allowed to be turned on for improvement of effciency.
Once the wired controller or the remote controller enters the Heating mode, this function will be turned on automatically.
Press Function in the Heating mode to enter the E-heater setting interface and then press Enter/Cancel to cancel this function.
Press Function to enter the E-heater setting status, if the E-heater function is not activated, and then press Enter/Cancel to activate it.
The setting of this function is shown as Fig.3.9.1 below:
Turn off the unit,without E-heater
function activated
Fig.3.9.1 E-heater Setting
3.10 Blow Setting
Blow function: After the unit is turned off, the water in evaporator of indoor unit will be automatically evaporated to avoid mildew.
In the Cooling or Dry mode, press Function till the unit enters the Blow setting status and then press Enter/Cancel to active this function.
When the Blow function is activated, press Function to the Blow setting status and then press Enter/Cancel to cancel this function.
Blow function setting is as shown in Fig.3.10.1
Turn off the unit,without Blow
function activated
Fig.3.9.1 E-heater Setting
66
Press Function repeatedly unitll
go to the E-heater setting status
Press Enter/Cancel to cancel this
setting
Press Function repeatedly unitll
go to the Blow setting status
Press Enter/Cancel to cancel this
setting
Press Enter/Cancel to activated the E-heater
function
Press Function repeatedly unitll go to
the E-heater setting function again
Press Enter/Cancel to activated the Blow
function
Press Function repeatedly unitll go to
the Blow setting function again
Installation and Maintenance
Service Manual