Table of Contents
Related Manuals for Gree Split Air Conditioner
Summary of Contents for Gree Split Air Conditioner
- Page 1 G R E E A I R C O N D I T I O N E R S Thank you for choosing GREE air conditioner for correct operation, please read this owner's manual carefully before operating the unit and keep...
-
Page 2: Table Of Contents
CONTENTS Operation and maintenance ■ Notices for operation...............1 ■ Notices for use................3 ■ Names and functions of each part..........4 ■ Operation of wireless remote control..........5 ■ Emergency operation..............10 ■ Clean and care................11 ■ Troubleshooting................13 Installation service ■ Notices for installation..............16 ■... -
Page 3: Operation And Maintenance Notices For Operation
Operation and maintenance-notices for operation ★ Earth: The ground be con- ★ Be sure to pull out the power plug ★ Select the most appropriate tem- perature. nected! when not using the air conditiiner for a long time. Keep room cool- er than outside about 5 degree. - Page 4 Notices for operation ★ To adjust the airflow direction Please don't cut off or damage the ★ power cords and control cords. appropriately. When operating the unit, to adjust the vertical air flow dire- If they are damaged, please ask the qualified ction by use of remote controller.And then, personnel to change them.
-
Page 5: Notices For Use
Notices for use Working principle and special functions for cooling Principle: Air conditioner absorbs heat in the room and transmit to outdoor and discharged, so that indoor ambient temperature decreased, its cooling capacity will increase or decrease by outdoor ambient temperature. Anti-freezing function If the unit is running in COOL mode and in low termperature, there will be frost formed on the heat exchanger, when indoor heat exchanger temperature decreased below 32 , the... -
Page 6: Names And Functions Of Each Part
Names and functions of each part Indoor unit Air in （1） （2） （5） Air out （4） （8） Front panel ⑴ Filter ⑵ ⑶ Guide louver Wall pipe ⑷ ⑸ Bind tape Outdoor unit ⑹ Connection wire ⑺ Drainage pipe Air in Remote control ⑻... -
Page 7: Operation Of Wireless Remote Control
Operation of remote control Names and functions of remote control buttons Note: Be sure that there are no obstructions between receiver and remote control; Don't drop or throw the remote control; Don't let any liquid in the remote control and put the remote control directly under the sunlight or any place where is very hot. -
Page 8: Names And Functions Of Remote Control Buttons
Operation of remote control Names and functions of remote control buttons NOTE: This Remote control is universal, it c o uld be used formany units, some buttons of this control which are not availabl e to this unit will not be described below. TIMER Timer button AUTO... -
Page 9: Operation Of Remote Control
Operation of remote control Names and functions of remote control buttons NOTE: This remote control is universal, it could be used formany units, some buttons of this control which are not available to this unit will not be described below. X-FAN X-FAN button Set X-FAN on (the characters of X-FAN will... -
Page 10: Introduction For Special Function
Operation of remote control Guide for operation-general operation 1.Press ON/OFF button to start the unit after powering the main unit on.(Note: Power the unit on every time, the big -guide louver and small-guide louver will be ON/OFF MODE closed firstly. 2.Press MODE button to select desired running mode. -
Page 11: Changing Batteries And Notices
Operation of remote control ¡ï About AUTO RUN When AUTO RUN mode is selected, the setting temperature will not be displayed on the LCD, the unit will be in accordance with the room temp. automatically to select the suitable running method and to make ambient comfortable. ¡ï... -
Page 12: Emergency Operation
Emergency Operation Displayer indicator light control of indoor unit It's a special selective button for the users ,who are not accustomed to the light at sleeping. ¡ñ Get the displayer indicator light on: When setting the light function,the mark will display on the remote controller screen by pressing this button. -
Page 13: Clean And Care
Clean and care CAUTION Turn power off and pull out the power plug before cleaning air conditioner. Or it may ● ● cause electric shock. Never sprinkle water on the indoor unit and the outdoor unit for cleaning because it ●... - Page 14 Clean and care ① Take down the air filter At the slot of surface panel to open an angle, pull the air filter downward and take it out. Cleaning ② To clean the dust adhering to the filters, you can either use a vacuum cleaner, or wash them with warm water (the water with the neutral detergent should below 45 ℃).
-
Page 15: Troubleshooting
Troubleshooting Warning Do not repair the air conditioner at your discretion. Incorrect repair may cause electric shock or fire, so please contact Authorized Service Center for professional repair. Following checks prior to contact may save your time and costs. Troubleshooting Phenomenon Air conditioner does not run upon immediately To protect the air conditioner upon immediate... - Page 16 Troubleshooting Phenomenon Troubleshooting Has the power been shut down? ● The unit can not run. Does power plug come loose from the socket? ● Is the circuit protection device tripped off or not? ● Is voltage higher or lower? ● (Tested by professionals) Break off Is the Timer correctly used?
- Page 17 Troubleshooting Troubleshooting Phenomenon In HEAT mode, when the temperature of ● Indoor unit cannot deliver air. indoor heat exchanger is very low, that will stop deliver air in order to prevent cool air. (Within 3min) In HEAT mode, when the outdoor temperature ●...
-
Page 18: Installation Service Notices For Installation
Installation service- Notices for installation Important Notices 1. The unit installation work must be done by qualified personnel according to the local rules and this manual. 2. If the air conditioner has not plug, directly connect it into the fixed circuit, a breaker should be installed in the fixed circuit. -
Page 19: Notices For Installation
Notices for installation Safety Requirements For Electric Appliances 1. The power supply should be used the rated voltage and AC exclusive circuit, the power cable diameter should be satisfied. Don't drag the power cable emphatically. It should be reliably earthed, and it should be connected to the special earth device, the installation work should be operated by the professional. -
Page 20: Installation Dimension Diagram
Installation dimension diagram Installation dimension diagram Installation dimension diagram Space to the ceiling Above 15cm Above 15cm Above Space to the wall Space to the wall cm cm Above Above Air outlet side Space to the floor The dimensions of the space necessary for correct ●... -
Page 21: Install Indoor Unit
Install indoor unit Install the rear panel 1.Always mount the rear panel horizontally. As the water drainage pipe at the left, when adjusting the rear panel, this side should not be too high; the right side should be slightly high. 2. -
Page 22: Install The Indoor Unit
Install indoor unit NOTE: When connecting the electric wire if the wire length is not enough, please contact with the authorized service shop to buy a exclusive electric wire that is long enough and the joint on the wire are not allowed. The electric wiring must be correctly connected, wrong connection may cause spare parts ●... -
Page 23: Install Outdoor Unit
Install outdoor unit Electric Wiring 1. Disassemble handle of right side plate or front side plate of outdoor unit. 2. Take off wire clamp, connect and fix power connect cord and power cord to terminal of line bank.Wiring should fit that of indoor unit. 3. - Page 24 Install outdoor unit Indoor unit check point ● Leak hunting Use soap water or leak hunting meter to check whether the joints is leak. Outdoor unit check point Fig.6 Outdoor condensation drainage (Heat pump type only) When the unit is heating, the condensing water and defrosting water can be drained out reliably through the drain hose.
-
Page 25: Check After Installation And Test Operation
Check after installation and test operation Check after installation Items to be checked Possible malfunction The unit may drop, shake or emit noise. Has it been fixed firmly? It may cause insufficient cooling(heating) Have you done the refrigerant leakage test? capacity. -
Page 26: Installation And Maintenance Of Healthy Filter
Installation and Maintenance of Healthy Filter Installation Instructions 1. Forcibly pull the panel for a specific angle from the two ends of the front panel according to the arrow direction. Then pull the air filter downwards to remove it. (See Fig.a) Fig. - Page 27 GREE 66162658 V1.0 GREE ELECTRIC APPLIANCES,I NC.OF ZHUHAI Website: http://www.gree.com...