Cisco Nexus 9504 Hardware Installation Manual page 78

Installing or Replacing a 3-kW AC Power Supply
1 Slide and hold the middle handle on the ejector lever
toward the end of the lever.
2 Fully rotate the release lever away from the front of
the module.
3 Slide the power supply into the open power supply
slot in the chassis until it stops. The front of the
module is about 0.25 inches (0.6 cm) in front of the
chassis.
f) Rotate the ejector lever toward the front of the power supply and be sure that the other end of the lever locks into the
chassis.
Cisco Nexus 9504 ACI-Mode Switch Hardware Installation Guide
68
Replacing or Installing Modules, Fan Trays, and Power Supplies
4 Rotate the lever toward the front of the module.
5 Make sure that the other end of the lever grabs the
front of the chassis to push the module onto the
connectors inside the slot.