In The Event Of A Problem; Warranty - TEFAL INTENSE PURE AIR PU4066 Manual

STORAGE
When you are not using the appliance, store it in a cool, dry place.

IN THE EVENT OF A PROBLEM

• Do not disassemble the appliance yourself. A poorly repaired appliance may be dangerous for the user.
• Check the troubleshooting table below before contacting an Approved Service Center:
Problem
The appliance will not
switch on.
The air flow does not
change automatically.
The flow is a lot weaker
than before.
There is an unpleasant
smell coming from the
air outlet.
The air quality indicator
does not change color.

WARRANTY

Do not use the appliance and contact an Approved Service Centre if:
- your appliance has been dropped;
- your appliance or its power cord are damaged;
- your appliance no longer functions properly.
You can find a list of Approved Service Centres on the ROWENTA and TEFAL international warranty cards.
HELP PROTECT THE ENVIRONMENT!
Your appliance contains many materials which can be recovered or recycled.
Take it to a collection point or an approved service centre for processing.
If this appliance uses batteries: help us look after the environment, by not throwing away your used
batteries. Instead, bring them to anyone of the special battery collection points. Do not throw them
away with your household waste.
These instructions can also be found on our internet site, at www.rowenta.com and www.tefal.com.
Check
Is the power cord connected?
Are all the display elements off?
Is there a power outage?
Is the front door closed?
Is the appliance in manual mode?
Does the filter need to be cleaned or
replaced?
Is the sensor lens covered with dust?
Does the light still indicate poor air
quality?
Does the indicator still indicate poor air
quality?
Does the indicator indicate excellent
air quality?
Solution
Connect the power cord to a plug with
the correct voltage.
Press the start button and select the
required function.
You can use your purifier once the
power turns on again.
Close the front door properly.
Select the correct operating mode.
Check the filter cleaning and
replacement frequencies and clean/
replace the filter(s) if necessary.
Check the filter cleaning and
replacement frequencies and clean/
replace the filter(s) if necessary.
Clean the sensor lens.
Set the sensor sensitivity to «low» or
«medium».
Set the sensor sensitivity to "high" or
"medium".
EN
11