Valor G3 739 Owner's Manual page 15

Cleaning your fireplace
Refi t and Check Window
1. To refi t the window, place the window against the
fi rebox's opening frame.
part of the window frame is at the bottom. The
top is marked TOP.
Bottom
of window
(wider frame)
2. While you hold the window, push in and turn the
two bottom spring-loaded bolts a quarter turn to
engage their pin into the fi rebox's tabs.
3. Push the top of the window against the fi rebox and
fasten the two top spring-loaded bolts a quarter
turn.
4. Pull out and release the top and bottom of the win-
dow and release it to ensure the springs return it.
5. Apply fi rm hand pressure around the window
frame to ensure it is sealed tight against the fi re-
box.
6. If the Hot Glass Warning plate has been removed
from the front lower corner of the window,
reinstall it by sliding it between the glass and the
frame as indicated below.
Hot Glass Plate
7. Re-install the front and barrier screen.
Ensure that the wider
WARNING
The window unit must be correctly
installed, fastened and sealed after
servicing or serious bodily injury and/or
damage to the appliance may result.
To ensure a safe operation:
• Double-check that the bottom of the
window frame is correctly installed on
the bottom support tabs;
• Verify that the bolts are hooked
properly to the window tabs then;
• Pull out and release the top and bottom
of the window to insure the springs
return it;
• Ensure the window is sealed before
operation.
WARNING
Failure to install the window correctly
can:
• Leak carbon monoxide.
• Affect the performance of the fireplace.
• Damage components.
• Cause overheating resulting in
dangerous
conditions.
Damage caused by incorrect window
installation is not covered by the Valor
Warranty.
WARNING
For safety purposes, make sure the
barrier screen is re-installed on the
fi replace front after maintenance.
15