Lubrication Guide - H&S 6180 Operator's Manual

GENERAL INFORMATION
IMPORTANT: Catch and dispose of fluid per local waste disposal regulations whenever service is performed
on hydraulic components, valves, cylinders, hoses, etc.
The operator should become familiar with all lubrication points and establish a systematic routine
to ensure complete and quick lubrication of the machine.
GREASING
There are numerous grease fittings on the spreader. If these are lubricated properly and often enough,
it will prolong the life of the spreader. (Grease every 20 hours, also before and after power washing.)
Make certain that the grease fittings are free of paint and dirt, force a high-quality grease into them until
the grease comes out around the shaft on the sleeve-type bearings. On the sealed ball bearings, grease
should be added slowly until a slight bead forms at the seals indicating the correct amount of lubricant.
Wipe off excess grease to prevent the accumulation of chaff and grit around the bearings.
PTO ASSEMBLY
Keep the male and female driving elements well lubricated and free sliding. Failure to observe this
precaution will result in excessive pressure being required to collapse or extend the assembly while
subject to operating torque. This excessive force may damage or displace the main shaft bearings. DO
NOT lubricate the shield surfaces. The shield surfaces must be kept dry, as dirt accumulation on them will
quickly cause these units to bind and not rotate. Be sure that the rotating integral shields are not dented or
damaged, as this also will result in excessive force being applied against the jackshaft. Damaged shields
also cause obvious difficulties when installing the assembly. If at any time the shields do not turn freely,
they should be checked to determine the cause, and repaired or cleaned. To avoid damage to the main
drive bearings, avoid turning sharp corners while PTO is running. Start and Stop PTO slowly to avoid
damage to the drive line.
(3) Zerks on
PTO Shaft

LUBRICATION GUIDE

-26-
Jack