Table of Contents
Advertisement
BEATER REMOVAL
The beater attachment can easily be removed for various reasons such as manure stock piling.
1. Remove bolts, nuts and lockwashers at the same location on each side (A).
2. Disconnect the quick disconnect PTO from the gearbox under the rear of the manure spreader and
remove the rear half of the PTO.
3. The remaining portion of the rear PTO has a roll pin that must be removed to slide the front portion
off of the PTO from the shaft.
4. After removal of both PTO halves, slide them together and store them in a safe place.
5. Securely attach a lifting chain to the lifting eyes at the top of the beater assembly (B).
6. Lift the beater assembly gently until alignment pegs are clear of the alignment holes.
7. Store the beater assembly on level ground with blocking as not to damage the drive system.
A
WHEEL HUBS
To adjust the wheel hubs, tighten the castellated nut on the spindle to the point where there is no
end-play and a slight drag on the bearings. Replace the cotter key with a new one of the correct size.
ADJUSTMENTS
-24-
B
Advertisement
Table of Contents
