Page 1
80 PT 80 PT O O O O O 80 PT 80 PT 80 PT MANURE SPREADER MANURE SPREADER MANURE SPREADER MANURE SPREADER MANURE SPREADER OPERA OPERA T T T T T OR’S MANU OPERA OR’S MANU OR’S MANU OR’S MANU AL OPERA OPERA OR’S MANU...
DEALER PRE-DELIVERY CHECK LIST AFTER COMPLETION, DEALER SHOULD REMOVE AND RETAIN FOR RECORDS After the Manure Spreader has been completely set-up, check to be certain it is in correct operating order before delivering to the customer. The following is a list of points to inspect. Check off each item as you have made the proper adjustments and found the item operating satisfactorily.
DEALER DELIVERY CHECK LIST AFTER COMPLETION, DEALER SHOULD REMOVE AND RETAIN FOR RECORDS This check list that follows is an important reminder of valuable information that should be passed on to the customer at the time this Manure Spreader is delivered. Check off each item as you explain it to the customer.
SAFETY INFORMATION YOUR SAFETY ALERT! IS INVOLVED. THIS SYMBOL IS USED THROUGHOUT THIS BOOK WHENEVER YOUR PERSONAL SAFETY IS INVOLVED. TAKE TIME TO BE CAREFUL. REMEMBER: THE CAREFUL OPERATOR IS THE BEST OPERATOR. MOST ACCIDENTS ARE CAUSED BY HUMAN ERROR. CERTAIN PRECAUTIONS MUST BE OBSERVED TO PREVENT THE POSSIBILITY OF INJURY OR DAMAGE.
SAFETY INFORMATION Keep signs in good condition. Immediately replace any missing or damaged signs. RECOGNIZE SAFETY INFORMATION This is the safety-alert symbol. When you see this symbol on your machine or in this manual, be alert to the potential for personal injury. Follow recommended precautions and safe operating practices.
SAFETY INFORMATION TRACTOR: This operators manual uses the term “Tractor” when identifying the power or the towing source. W A R N I N G TO PREVENT SERIOUS INJURY OR DEATH BEFORE YOU ATTEMPT TO OPERATE THIS EQUIPMENT, READ AND STUDY THE FOLLOWING INFORMATION.
SET-UP & ASSEMBLY NOTE: Determine right or left side of the Manure Spreader by viewing it from the rear. If instructions or parts lists call for hardened bolts, refer to the Cap Screw Torque Value Chart. PREPARING MANURE SPREADER The Manure Spreader may be shipped without the wheels/tires installed. 1.
PREPARING FOR OPERATION TRACTOR CONNECTIONS Tractor Hitch Fasten the spreader hitch to the drawbar with a hitch pin with a safety locking device. Remove the weight from the jack (jack is not to be used when spreader is loaded). Remove jack from pipe mount and place on convenient storage mount located on the left front of spreader.
OPERATION LOADING In freezing weather, make certain that the apron chain is not frozen to the spreader floor or any lumps of manure are frozen to the floor. Begin loading the spreader at the front end and work toward the rear until loading is completed.
ADJUSTMENTS DRIVE CHAIN To adjust the main drive chain, loosen the three bolts holding the front center panel on to the spreader. Slide the panel toward the right side of the spreader until the proper tension on chain is reached. There should be 1/2” deflection at the center of the drive chain when it is properly Bolts adjusted.
SERVICE SHEAR BOLT Spare The beater and apron drive are protected Shear by one shear bolt. Two shear bolts are Bolts provided. Shearing of the bolt is normally due to foreign objects in the manure, or starting the spreader PTO too quickly Shear with high tractor RPM’s.
Page 20
SERVICE TIRES & WHEELS Check the tire pressure after every 50 hours of operation. Tires should be inflated to the appropriate pressure listed in the table. Tire Pressure 6.70x15 32 PSI Wheel lug torque should be checked after every 50 hours of operation and tightened to the appropriate torque.
LUBRICATION The operator should become familiar with all lubrication points and establish a systematic routine to insure complete and quick lubrication of the machine. GENERAL INFORMATION IMPORTANT: Catch and dispose of fluid per local waste disposal regulations whenever service is performed on hydraulic components, valves, cylinders, hoses, etc.
Page 23
LUBRICATION GREASE ZERK LOCATIONS (1) on each front idler (1) on jack sprocket behind the shields (1) on the side shaft (1) at each end of the PTO shaft (1) on each end of the drive shaft -21-...
DECAL LOCATION Your H&S Manure Spreader was manufactured with operator safety in mind. Located on the Manure Spreader are various decals to aid in operation, and warn of danger or caution areas. Pay close attention to all decals on your Manure Spreader. DO NOT REMOVE ANY OF THESE DECALS.
TROUBLESHOOTING WARNING: MAKE SURE THAT THE TRACTOR IS SHUT OFF AND SPREADER CAN NOT MOVE BEFORE SERVICING THE MANURE SPREADER. MAINTENANCE AND REPAIR SERVICE WORK TO BE PERFORMED BY A QUALIFIED SERVICE PERSON ONLY. TROUBLE... POSSIBLE CAUSE... POSSIBLE REMEDY... Beater Does Not Turn PTO Not Turning Engage Tractor PTO Beater Not Engaged...
Page 30
H&S MFG H&S MFG ..CO H&S MFG CO ..H&S MFG H&S MFG products approved for the FEMA FEMA FEMA FEMA FEMA SEAL OF Q SEAL OF Q U U U U U ALITY SEAL OF Q ALITY ALITY...