H&S 6180 Operator's Manual

H&S 6180 Operator's Manual

Manure spreader

Advertisement

Quick Links

MANURE
MANURE
SPREADER
SPREADER
READ AND UNDERSTAND THIS MANUAL BEFORE
READ AND UNDERSTAND THIS MANUAL BEFORE
OPERATING THIS EQUIPMENT. UNSAFE OPERATION
OPERATING THIS EQUIPMENT. UNSAFE OPERATION
OR MAINTENANCE OF THIS EQUIPMENT CAN RESULT
OR MAINTENANCE OF THIS EQUIPMENT CAN RESULT
IN SERIOUS INJURY OR DEATH.
IN SERIOUS INJURY OR DEATH.
PS6180 Starting Ser. #221PS80001
PS6180 Starting Ser. #221PS80001
6180
6180
WARNING
WARNING
Part #92785
Part #92785
O O
P P
E E
R R
A A
T T
O O
R R
S S
Rev. #00
Rev. #00
HSMFG122122
HSMFG122122
M
M
A A
N N
U U
A A
L L

Advertisement

Table of Contents
loading

Summary of Contents for H&S 6180

  • Page 1 6180 6180 MANURE MANURE SPREADER SPREADER WARNING WARNING READ AND UNDERSTAND THIS MANUAL BEFORE READ AND UNDERSTAND THIS MANUAL BEFORE OPERATING THIS EQUIPMENT. UNSAFE OPERATION OPERATING THIS EQUIPMENT. UNSAFE OPERATION OR MAINTENANCE OF THIS EQUIPMENT CAN RESULT OR MAINTENANCE OF THIS EQUIPMENT CAN RESULT IN SERIOUS INJURY OR DEATH.
  • Page 2: Table Of Contents

    CONTENTS Warranty ..............1-2 Manufacturer’s Statement .
  • Page 3: Warranty

    WARRANTY H&S Manufacturing Co., Inc. (“H&S”) warrants this product to be free from defect in material and workman- ship. Except as noted below, this warranty term is twelve (12) months on parts and labor from the date of delivery of the product to the original purchaser by an authorized H&S dealer. Under this warranty, H&S will repair or replace, at its option, any covered part which is found to be defective in material or workmanship during the applicable warranty term.
  • Page 4: Manufacturer's Statement

    WARRANTY For these warranty terms to be in effect the selling authorized H&S dealer and/or the customer must submit the warranty registration to H&S. THERE ARE NO WARRANTIES WHICH EXTEND BEYOND THE DESCRIPTION ON THE FACE OF THIS WARRANTY. H&S and the companies affiliated with it make no warranties, representations, or promises, express or implied, as to the performance or freedom from defect of its products other than those set forth above and NO IMPLIED WARRANTY OF MERCHANTABILITY, FITNESS OR FITNESS FOR A PARTICULAR PURPOSE IS MADE.
  • Page 6 Intentionally Left Blank...
  • Page 7: Dealer Pre-Delivery Checklist

    H&S DEALER PRE-DELIVERY CHECKLIST AFTER COMPLETION, DEALER SHOULD REMOVE AND RETAIN FOR RECORDS After the Manure Spreader has been completely set up, check to be certain it is in correct operating order before delivering to the customer. The following is a list of points to inspect. Check off each item as you have made the proper adjustments and found the item operating satisfactorily.
  • Page 8 Intentionally Left Blank...
  • Page 9: Dealer Delivery Checklist

    DEALER DELIVERY CHECKLIST AFTER COMPLETION, DEALER SHOULD REMOVE AND RETAIN FOR RECORDS This checklist that follows is an important reminder of valuable information that should be passed on to the customer at the time this Manure Spreader is delivered. Check off each item as you explain it to the customer. This delivery checklist, when properly filled out and signed, assures the customer that the pre-delivery service was satisfactorily performed.
  • Page 10 Intentionally Left Blank...
  • Page 11: Safety Information - Be Alert Symbol

    SAFETY INFORMATION YOUR SAFETY ALERT! IS INVOLVED. THIS SYMBOL IS USED THROUGHOUT THIS BOOK WHENEVER YOUR PERSONAL SAFETY IS INVOLVED. TAKE TIME TO BE CAREFUL. REMEMBER: THE CAREFUL OPERATOR IS THE BEST OPERATOR. MOST ACCIDENTS ARE CAUSED BY HUMAN ERROR. CERTAIN PRECAUTIONS MUST BE OBSERVED TO PREVENT THE POSSIBILITY OF INJURY OR DAMAGE.
  • Page 12: Explanation Of Safety Signs

    SAFETY INFORMATION RECOGNIZE SAFETY INFORMATION This is the safety alert symbol. When you see this symbol on your machine or in this manual, be alert to the potential for personal injury. Follow recommended precautions and safe operating practices. UNDERSTAND SIGNAL WORDS A signal word - DANGER, WARNING, or CAUTION - is used with the safety alert symbol.
  • Page 13: Safety Decals

    SAFETY DECALS -11-...
  • Page 14 SAFETY DECALS -12-...
  • Page 15 SAFETY DECALS -13-...
  • Page 16: Safety Information - Warning - Owner Must Read And Understand

    SAFETY INFORMATION TRACTOR: This operator’s manual uses the term “Tractor” when identifying the power source. W A R N I N G TO PREVENT SERIOUS INJURY OR DEATH BEFORE YOU ATTEMPT TO OPERATE THIS EQUIPMENT, READ AND STUDY THE FOLLOWING INFORMATION.
  • Page 17: Cap Screw Torque Values

    -15-...
  • Page 18: Set-Up & Assembly

    SET-UP & ASSEMBLY WARNING: Some photographs used in the following pages show guards or shields removed for clarification. Never operate machine until these guards or shields are in proper operating position. NOTE: Determine right or left side of the Manure Spreader by viewing it from the rear. If instructions or parts lists call for hardened bolts, refer to the Cap Screw Torques Value page to identify.
  • Page 19: Transporting

    TRANSPORTING TRANSPORT LIGHTING & REFLECTORS When transporting on the highway, connect the spreader to the tractor with a lighting power cord. The lighting system is to be connected to the 7 pin power receptacle (per SAEJ560B) on your tractor. If your tractor is not equipped with the proper receptacle, see your tractor dealer for details.
  • Page 20: Preparing For Operation

    PREPARING FOR OPERATION TRACTOR CONNECTIONS Tractor Hitch Fasten the spreader hitch to the drawbar with a hitch pin with a safety locking device. Use 1-1/2” diameter hitch pin to pull spreader. Remove the weight from the jack (jack is not to be used when spreader is loaded).
  • Page 21 PREPARING FOR OPERATION PTO ASSEMBLY Attach the PTO of the spreader to the tractor by sliding the spring loaded locking collar on PTO yoke rearward, then sliding it onto the tractor PTO shaft. Release spring loaded collar. Be sure the pins fall into the groove of the tractor PTO shaft and collar snaps forward into locking position.
  • Page 22: Operation

    OPERATION EMERGENCY SHUTDOWN If a foreign object becomes lodged in the beater area and disengages the torque limiting clutch, stop the hydraulic drive apron and disengage the PTO. Stop the tractor engine, remove the ignition key, and allow all mechanisms to stop before cleaning or working on the spreader. LOADING Begin loading the spreader at the front end and work toward the rear until loading is completed.
  • Page 23 OPERATION OPTIONAL - REVERSING THE MAIN APRON If the manure spreader is equipped with an optional reversing valve that allows the operator to reverse the main apron if a problem arises such as an obstruction in the beater area, follow the steps below. CAUTION: DO NOT RUN THE APRON CHAIN IN REVERSE LONGER THAN NECESSSARY AS DAMAGE COULD ACCUR IF THE LOAD IS BACKED INTO THE FRONT OF THE MANURE SPREADER.
  • Page 24: Service & Adjustments

    SERVICING NOTE: Be certain to disconnect all sources of power before servicing. Keep pant cuffs and loose clothing away from all drives as well as the other moving parts. Keep off the equipment when in use, and keep all shields in place. Do not attempt to clean, grease or lubricate while the machine is running. Never allow riders in or on the machine.
  • Page 25: Adjustments

    ADJUSTMENTS MAIN APRON ADJUSTMENT Tighten the two adjusting bolts on both sides (1 on each front corner of the spreader - see circled area in the pictures below) equally so that when properly tensioned, the apron chain on each side should sit 1/16”...
  • Page 26 ADJUSTMENTS BEATER REMOVAL The beater attachment can easily be removed for various reasons such as manure stock piling. 1. Remove bolts, nuts and lockwashers at the same location on each side (A). 2. Disconnect the quick disconnect PTO from the gearbox under the rear of the manure spreader and remove the rear half of the PTO.
  • Page 27: Optional Equipment

    OPTIONAL EQUIPMENT ELECTRIC ADJUST HYDRAULIC VARIABLE SPEED APRON CONTROL The optional electric adjust valve allows you to adjust your apron speed from the tractor cab if the tractor is not equipped with a variable speed on the flow control. MAIN APRON REVERSING VALVE KIT The optional reversing valve allows the operator to reverse the main apron if a problem arises such as an obstruction in the beater area 4-WHEEL ELECTRIC-OVER-HYDRAULIC DISC BRAKES...
  • Page 28: Lubrication Guide

    LUBRICATION GUIDE GENERAL INFORMATION IMPORTANT: Catch and dispose of fluid per local waste disposal regulations whenever service is performed on hydraulic components, valves, cylinders, hoses, etc. The operator should become familiar with all lubrication points and establish a systematic routine to ensure complete and quick lubrication of the machine.
  • Page 29 LUBRICATION GUIDE (1) Zerk on each end of front idler shaft Remote Zerks Remote Zerks Top LH Zerk - Left Side Tandem Pivot (5) for the main drive shaft Bottom LH Zerk - Right Side Tandem Pivot bearings under the spreader Top Center Zerk - Rear Drive Shaft Bearing Bottom RH Zerk - Left Side Drive Shaft Bearing Top RH Zerk - Right Side Drive Shaft Bearing...
  • Page 30: Decal Location

    DECAL LOCATION Your H&S Manure Spreader was manufactured with operator safety in mind. Located on the manure spreader are various decals to aid in operation, and warn of danger or caution areas. Pay close attention to all decals on your Manure Spreader. DO NOT REMOVE ANY OF THESE DECALS.
  • Page 31 DECAL LOCATION 11599 093366 093020 82602 9194A 12794 1494L 9194A 82602 -29-...
  • Page 32 DECAL LOCATION 94010 94013 86060 1494J 1906F 72203A 9194B DCAMB DCAMB 1494K 1494K 9194A 9194A 51010 51010 9194A 54033 54045 96654 84044 1494A -30-...
  • Page 33 DECAL LOCATION 093020 9194A 94008 94011 1906F DCAMB 51010 1906F DCAMB 1906C 86060 11599 1494J 1906F DCAMB 11599 -31-...
  • Page 34 DECAL LOCATION 12794 71494A UNDER SHIELD JD5922 DCRED JD5922 1906C 86060 11599 1494J 1906F DCAMB 11599 -32-...
  • Page 35 DECAL LOCATION 94012 94009 DCAMB 1906F 51010 DCAMB 9194A 093020 -33-...
  • Page 36: Troubleshooting

    TROUBLESHOOTING WARNING: MAKE SURE THAT THE TRACTOR IS SHUT OFF AND THE SPREADER CANNOT MOVE BEFORE SERVICING THE MANURE SPREADER. MAINTENANCE AND REPAIR SERVICE WORK TO BE PERFORMED BY A QUALIFIED SERVICE PERSON ONLY. TROUBLE... POSSIBLE CAUSE... POSSIBLE REMEDY... Beater Will Not Run Tractor PTO Not Turning Engage Tractor PTO Apron Does Not Turn...
  • Page 37: Service Notes

    SERVICE NOTES __________________________________________________ __________________________________________________ __________________________________________________ __________________________________________________ __________________________________________________ __________________________________________________ __________________________________________________ __________________________________________________ __________________________________________________ __________________________________________________ __________________________________________________ __________________________________________________ __________________________________________________ __________________________________________________ __________________________________________________ __________________________________________________ __________________________________________________ __________________________________________________ __________________________________________________ __________________________________________________ __________________________________________________ __________________________________________________ __________________________________________________ -35-...
  • Page 38 SERVICE NOTES __________________________________________________ __________________________________________________ __________________________________________________ __________________________________________________ __________________________________________________ __________________________________________________ __________________________________________________ __________________________________________________ __________________________________________________ __________________________________________________ __________________________________________________ __________________________________________________ __________________________________________________ __________________________________________________ __________________________________________________ __________________________________________________ __________________________________________________ __________________________________________________ __________________________________________________ __________________________________________________ __________________________________________________ __________________________________________________ __________________________________________________ -36-...
  • Page 40 H&S MFG. CO. products approved for the FEMA SEAL OF QUALITY Manufactured By: H&S MANUFACTURING CO., INC. 2608 S. HUME AVE. MARSHFIELD, WI 54449 (715) 387-3414 | hsmfgco.com...

Table of Contents