Setting Up And Using The Headset; Adjusting The Volume - Sennheiser EPOS SDW 5000 Series User Manual

31

settInG UP AnD UsInG tHe HeADset

Setting up and using the headset

Adjusting the volume

CAUTION
!
Hearing damage due to high volumes!
Listening at high volume levels for long periods can lead to permanent hearing defects.
set the volume to a low level before putting on the headset.
X
Do not continuously expose yourself to high volumes.
X
1
Adjusting the volume of the audio signal
1
Make a call (see page 35) or
X
play music (see page 44).
Move the Mute & Volume button as shown to adjust
X
the volume.
When the minimum or maximum volume is reached, the voice prompt "Volume min" or "Volume max" is announced in the
headset. When the voice prompts are disabled, you hear a beep in the headset instead.
Adjusting the sidetone
the sidetone in the sDW headsets can be adjusted via ePos Connect.
SDW 5000 series headset system
You can adjust two independent volume settings for the
headset:
• speaker volume, audio signal
• volume for the ring tone, the beeps and the voice
prompts
the direction of the volume buttons could be swapped.
Put on the headset.
X
Choose your audio source.
X
the corresponding LeD lights up.
Adjusting the volume of the ring tone, the beeps and
the voice prompts
2
Make sure that the headset is in idle mode (no active
X
call or music reproduction).
Move the Mute & Volume button as shown to adjust
X
the volume.