Using The Motion Sensor - Sennheiser EPOS SDW 5000 Series User Manual

45

UsInG tHe MotIon sensoR

Using the motion sensor
the headset is equipped with a motion sensor that registers when the headset is put in or out of rest position.
Enabling/disabling the motion sensor
Put on the headset and place the ear cup on the left
X
ear.
Using the motion sensor
SDW 5000 series headset system
"Motion sensor on"
"Motion sensor o "
Press the volume button as shown and simultaneously
X
the hook button. Hold the buttons until you hear three
beeps.
the motion sensor is enabled/disabled and you can
choose your wearing side. the voice prompt "Motion
sensor on" or "Motion sensor off" is announced.
You can also change this setting via
ePos Connect.
Lift the headset from the desk and put it on.
X
the sensor registers motion and the incoming call is
accepted.
SDW 30 HS | SDW 60 HS:
Music will be paused when you lay down the headset and
resumed when you put on the headset again.