Setting Up And Using The Headset; Adjusting The Volume - Sennheiser SDW 10 HS User Manual

28

settInG UP AnD UsInG tHe HeADset

Setting up and using the headset

Adjusting the volume

CAUTION
!
Hearing damage due to high volumes!
Listening at high volume levels for long periods can lead to permanent hearing defects.
set the volume to a low level before putting on the headset.
Do not continuously expose yourself to high volumes.
Adjusting the volume of the audio signal, the ring tone and the voice prompts
You can adjust two independent volume settings for the headset:
• speaker volume: can be adjusted during an active call or during music reproduction,
• volume for the ring tone, the beeps and the voice prompts:
can be adjusted in idle mode (no active call or music reproduction)
1
Put on the headset.
Choose your audio source.
the corresponding LeD lights up.
Swapping the direction of the volume buttons
You can change the direction of the Volume button's up/down function if, for example, you want to wear the headset
on the other ear. If the motion sensor is enabled, the volume keys automatically swap direction when you change the
wearing side.
SDW 5000 series headset system
3s
"Swap volume keys"
2
Push the Mute & Volume button up or down to adjust
the volume.
When the minimum or maximum volume is reached,
the voice prompt "Volume min" or "Volume max" is
announced in the headset. When the voice prompts are
disabled, you hear a beep in the headset instead.
Press and hold the Mute & Volume button (no active
call or music reproduction):
the direction of the button's volume up/down function
is changed. the voice prompt "Swap volume keys" is
announced in the headset.
You can also change this settings via
Headsetup™ Pro.