Table of Contents
Advertisement
If you do not find any additional connectors available (either because they were not
supplied, or they are all in use), you will have to buy a ''splitter'' or a ''Y-connector.''
These also can be found at most computer stores. If you are in a hurry to get started,
you probably can unplug the power connector from your 5.25" floppy drive (if you
have one) and plug it into your CD-ROM drive. You will be able to use your CD-ROM
drive until you have the opportunity to buy a ''splitter'' or ''Y-connector.'' (Of course,
you will lose the use of your 5.25" drive until you buy a splitter/Y-connector.)
If your computer has only a 3.5" floppy disk drive, you may find that you do not have
a power connector that is the correct size to plug into your CD-ROM drive. Once
again, you can turn to your local computer store for a splitter to solve this problem,
or you might find an adapter that converts the smaller sized power plug found on a
3.5" drive to the size required for your CD-ROM drive.
A third cable, an audio cable, must be used if there is a soundboard in your system.
This cable runs from the four pin audio output connector on the rear panel of your
drive to your soundboard. See page 33 for more information about audio cables.
Installation of your internal drive is now complete. Skip to page 32.
External Drive Installation
YOUR TASK:
Connect cables from your external drive to your PC
or Mac. Check to see if switch, dial and terminator
settings need to be adjusted.
YOUR OBJECTIVE:
A well-functioning drive that does not conflict with
any other peripherals in your computer system.
YOUR METHOD:
Follow directions below for making cable
connections. Review your current computer set-up
to see if the potential for conflicts exists. If so, make
necessary switch, dial and/or terminator changes.
If you are installing a single PX-65CS, and you have no other SCSI peripherals attached
to your system, you should leave the switches, dial and terminator found on the rear
panel of your drive at their factory settings. If you do have additional SCSI peripherals
(e.g., scanner, printer) attached to your computer, you may need to change your
switch, dial and terminator settings. See Chapters 6 and 7 for information on how to
change these settings.
If you are installing a single PX-65CS external drive, connect it as shown on the next
page:
CHAPTER 8 ---- Hardware Installation
PX-63CS/PX-65CS OPERATION MANUAL
29
Advertisement
Table of Contents
